Remove all existing partitions (select partition and click -)Ĭreate the following partitions (click +) Select your system drive and under Partitioning, select I will configure partitioning. If your system drive is not sda, instead of the install completing without any user interaction, your install will stop with the following screen.Īt this point, you are prompted to click Installation Destination to configure the drive partitioning. (root partition) is the remaining free space. Part swap -fstype="swap" -ondisk=sda -size=32000 Part /boot -fstype="xfs" -ondisk=sda -size=1000 Note that the config only applies to sda. The following shows the disk partitioning kickstart config. User interaction will be required during installation to configure partitioning before the automated install can continue. In some cases, such as installing from a USB drive, the system drive will be detected as /dev/sdb. However, this kickstart config expects the system drive to be /dev/sda.
The Autodesk custom CentOS 7.2 ISO uses a kickstart configuration to automate the installation process. Migrating to CentOS 7.2 requires a complete system rebuild using the Autodesk custom CentOS 7.2 ISO. Supported operating systems are CentOS 7.2. With the release of Flame Family 2018 (Flame, Flare and Flame Assist) on Linux, Red Hat is no longer supported.
0 kommentar(er)
